Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Manual modification of the RF Module equation

Posted 2020年3月28日 GMT-4 20:49 Version 5.2a 2 Replies

Israel Alves Oliveira
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Good night:

Is there any way to modify the Electric displacement model manually? I am using the RF Module to analyze periodic structures, however, according to the literature, the relative permissiveness is obtained through the equation εr = (n - ik) ² + 2nik, the latter term not appearing in COMSOL and I would like to insert.

2 Replies Last Post 2020年3月29日 GMT-4 17:52
Dave Greve
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2020年3月29日 GMT-4 14:17

I'm not sure I understand the question. You can insert a complex relative permittivity for any material.

I'm not sure I understand the question. You can insert a complex relative permittivity for any material.
Israel Alves Oliveira
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 5 years ago 2020年3月29日 GMT-4 17:52

I managed to understand. In fact, I had a doubt because the other term didn't appear. In fact, it is already inserted, I made the mistake. Thank you, Dave.

I managed to understand. In fact, I had a doubt because the other term didn't appear. In fact, it is already inserted, I made the mistake. Thank you, Dave.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content