Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Create a hole on a surface during simulation

Posted 2020年5月25日 GMT-4 04:34 Heat Transfer, Geometry, Modeling Tools & Definitions Version 5.3 0 Replies

Marcel Jung
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello dear,

is it possible to create holes in the model during the simulation? I would like to simulate the temperature input during laser drilling and it would be very helpful to create the model with the corresponding hole after drilling so that this is taken into account for the second hole.

Is there an application for this in Comsol? Or is there an alternative how I can display the borehole after drilling?

Thank you and greetings Marcel Jung

0 Replies Last Post 2020年5月25日 GMT-4 04:34
COMSOL Moderator

Hello Marcel Jung

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content