Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Surface recombination of Si solar cell simulation

Please login with a confirmed email address before reporting spam

Hello

I am working on Si solar cell simulation to get the J-V curve, meanwhile I am thinking to take into accout the surface recombination of the cell. However, the interface of the junctions alway shows not applicable when I applied the Trap assisted surface recombination to the simulation. My queaston is how to address this issue or is that possible to perform surface recombination in COMSOL?

Thanks a lot



0 Replies Last Post 2020年5月27日 GMT-4 15:27
COMSOL Moderator

Hello Peng Wu

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.