Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Setting pressure point constraint in closed fluid mechanics problem
Posted 2010年1月15日 GMT-5 18:37 Version 4.2a 6 Replies
Please login with a confirmed email address before reporting spam
My problem involves a closed sphere filled with magnetic fluid put near a rectangular bar magnet. Physically when this is done there is a pressure build up in the fluid because of the magnetic body force generated and there is no steady state flow.
The magnetic fluid magnetization is kept simple and is described by the linear relation M=Xi *H in the different directions. The volume body force density is given as follows
Fx=Mx*d(Hx,x)+My*d(Hx,y)+Mz*d(Hx,z)
Fy=Mx*d(Hy,x)+My*d(Hy,y)+Mz*d(Hy,z)
Fz=Mx*d(Hz,x)+My*d(Hz,y)+Mz*d(Hz,z)
The boundary condition on the fluid is no-slip and continuity for the normal magnetic flux density.
If I specify a non-correct pressure then COMSOL gives me a static result of positive flow when this is not physically correct. The problem I am having is I dont know the pressure point constraint that I need to specify so that the problem converges. I would like for the problem to solve the pressure automatically.
I have attached the problem. Any help on this will greatly help me and people with similar problems in closed fluid mechanics problems
Thanks
Shahriar
Attachments:
Hello Shahriar Khushrushahi
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I have the same problem, could you find any answer for pressure point condition?
Thanks,
Giti
Please login with a confirmed email address before reporting spam
Please login with a confirmed email address before reporting spam
Please login with a confirmed email address before reporting spam
as for all physics one need to sett get dependent variables defined fully, in FCD the pressure is often a relative or gauge pressure, and the results are correct for any value + a constant at some time one need to fix this constant and if a p=o output BC is not used, and setting a "p=0" at one point within the fluid domain might be enough to define the constant (=0 in this case)
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
i know it was a very long time ago.
could you send me the latest modell about ferromagnetic fluid. Or maybe the modell that has been presented on comsol converece on 2011 with title "Planar Geometry Ferrofluid Flows in Spatially Uniform Sinusoidally Time-varying Magnetic
Fields"
i'm trying to going into these theme but it's very complex.
thank you
best regards
hidayat
Please login with a confirmed email address before reporting spam
Hi Shahriar Khushrushahi,
i know it was a very long time ago.
could you send me the latest modell about ferromagnetic fluid. Or maybe the modell that has been presented on comsol converece on 2011 with title "Planar Geometry Ferrofluid Flows in Spatially Uniform Sinusoidally Time-varying Magnetic
Fields"
i'm trying to going into these theme but it's very complex.
thank you
best regards
hidayat