Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Parametric Sweep messes up Geometry
Posted 2020年9月22日 GMT-4 16:31 Geometry, Mesh, Parameters, Variables, & Functions Version 5.4 3 Replies
Please login with a confirmed email address before reporting spam
Hello all!
I am simulating Heat Transfer in Solid with Surface-to-Surface Radiation. During the simulations I want to vary the angles of some conical heat shields. I use parametric sweep for this, but when I run the sweep it messes up my geometry and the study cannot be done.
It seem that when I sweep the angles that a selection in my geometry gets changed and the subsequent sequence of the geometry is errorful.
Why is this so? And, can it be fixed?
Best regards, Yao
Please login with a confirmed email address before reporting spam
I have had this happen when part of the geometry disappears or otherwise changes for some value of the parametric sweep. Have you looked closely at the geometry before and after parameter value where the error appears?
Please login with a confirmed email address before reporting spam
I have had this happen when part of the geometry disappears or otherwise changes for some value of the parametric sweep. Have you looked closely at the geometry before and after parameter value where the error appears?
Yeah, I have. The selection in a "Delete Entities" gets changed, such that some objects/domains are not deleted. This is very impractical in a setting where I want to sweep parameters.
Can I ask, how did you solve your issue?
Best, Yao
Please login with a confirmed email address before reporting spam
>
Can I ask, how did you solve your issue?
Best, Yao
I changed the sweep or maybe the geometry to avoid the problem.