Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to switch the coarser mesh elements with the finer mesh elements?

Posted 2020年10月1日 GMT-4 10:06 Structural & Acoustics, Mesh, Structural Mechanics Version 5.3 1 Reply

Mohamed Moursy
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello there,

I have a question in COMSOL structural mechanics module. Considering the highlighted area in the figure, does someone know how to switch the mesh that the smaller elements are on the outside and the bigger are on the inside?

Thanks!!

Attachments:

1 Reply Last Post 2020年10月3日 GMT-4 21:40
Robert Koslover Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2020年10月3日 GMT-4 21:40

You don't have to use the default mesh-generation settings. You can set the meshing parameters in a variety of user-defined ways, including specifying minimum mesh sizes separately within various volumes, surfaces, edges, and around points. I encourage you to experiment with them.

-------------------
Scientific Applications & Research Associates (SARA) Inc.
www.comsol.com/partners-consultants/certified-consultants/sara
You don't have to use the default mesh-generation settings. You can set the meshing parameters in a variety of user-defined ways, including specifying minimum mesh sizes separately within various volumes, surfaces, edges, and around points. I encourage you to experiment with them.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content