Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Mesh generation failed

Posted 2012年4月12日 GMT-4 05:04 Low-Frequency Electromagnetics Version 4.3 1 Reply

Sin Kim
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi all,

I am trying to mesh a cylinder wrapped with a helix (3D geometry) but when I try to generate the free tetrahedral mesh for this geometry the comsol 4.2 always reports error and cannot generate the mesh for this geometry. From certain published results that have utilized the same geometry I came to know that the helix has a point contact with the cylinder in 2D and it has a line contact in 3D with the cylinder and hence the volume mesh cannot be generated, therefore blending between the helix and cylinder is necessary in order to have a good volume mesh. Does any body knows how to use the blending feature in comsol 4.2 or how to generate the mesh for this geometry.

Thanks in advance
1 Reply Last Post 2012年7月24日 GMT-4 15:51
COMSOL Moderator

Hello Sin Kim

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Blaise Cole
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年7月24日 GMT-4 15:51
I am having the same problem as well. It works fine as long as there is a small distance between the cylinder and the helix but not when they are in contact. I havent found a way around this problem yet either.
I am having the same problem as well. It works fine as long as there is a small distance between the cylinder and the helix but not when they are in contact. I havent found a way around this problem yet either.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content