Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Self and mutual inductance Calculation 3D (Ivar Kjelberg)

Posted 2012年4月27日 GMT-4 02:57 Low-Frequency Electromagnetics, Results & Visualization, Studies & Solvers Version 4.2a 1 Reply

Jad Taki
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am a newbie in Comsol and i am using the version 4.2a right now. I am trying to calculate the self and mutual inductance between 2 coils in 3D. i tried to search for different solutions in the forums here but none of the them solve my problem. I can't attach my model here because it is so big so i really appreciate if u can help me and mention your email here so i can send the model to u and sorry if it takes too long to open or compile.

I am having few problems with it:

1. I can't find the best way to excit the primary coil, i was thinking of creating an air cylinder between the beginning and the end of the coil ( like the tutoriel inductor_3D) and to put a terminal and ground on these endings. is it the best way for my case or is there an easier way to excit the primary coil??

2. To calculate the inductances (self and mutual) , i found in different forums different solutions but what is the best one for my case using the newer version of Comsol and can you please explain it in details because i am a beginner.


Thanks in advance

Jad TAKI

1 Reply Last Post 2013年5月6日 GMT-4 08:39
COMSOL Moderator

Hello Jad Taki

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Khalid Hameed
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年5月6日 GMT-4 08:39
You can excite your coil with numerious methods, either by using single turn coil domain or multiturn coil domain. The best way is to use single turn coil domain and use gap feed for closed loop geometry. In additon try constructing your geometry via work plane and the revolve to get your desired geometry.
When you are successful in calculating inducatance of single coil then you can easily compute mutual inductance by using the formula in plot window mf.VCoil_2/1[A]/mf.iomega

Regards
Khalid
You can excite your coil with numerious methods, either by using single turn coil domain or multiturn coil domain. The best way is to use single turn coil domain and use gap feed for closed loop geometry. In additon try constructing your geometry via work plane and the revolve to get your desired geometry. When you are successful in calculating inducatance of single coil then you can easily compute mutual inductance by using the formula in plot window mf.VCoil_2/1[A]/mf.iomega Regards Khalid

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content