Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

3D Magnetic System in Assembly-mode

Posted 2021年3月16日 GMT-4 06:54 Low-Frequency Electromagnetics, Fluid & Heat 1 Reply

Dominik Thomalla
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I'm trying to simulate a 3D Magnetic system. The System is like a FluidClutch with MRF. In order to rotate a disc in the Fluid i need the assembly mode. But when i try to simulate my system in assembly mode its not geeting to an end. Simulating the sytem in Formunion works as it should,

I create Pairs automaticly in Form Assembly and i apply continuity to the pair. But it's not working

1 Reply Last Post 2021年3月16日 GMT-4 07:48
Dominik Thomalla
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年3月16日 GMT-4 07:48

Here is my Modell

Here is my Modell

Attachments:

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content