Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Lineair temperature increase in Heat transfer

Posted 2012年5月8日 GMT-4 11:51 Version 4.2a 3 Replies

Frank Thomson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi there,

I am modeling an autoclave and i am trying to increase the temperature at specific time intervals. I entered the formula for the temperature increase in the variables but i doenst work.

This is the formula. ( every 2 minutes the temperature will go up 2 degrees C.)
T=T0+2t

What is the best way to do this?

thanks in advance.
3 Replies Last Post 2012年5月9日 GMT-4 03:01
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年5月8日 GMT-4 12:14
Hi

I believe something like

T=T0+2[K]/(60[s])*t

should work better (assuming T0 has units of Kelvin) if you have left the time in the default "seconds" units. 2*t has units of seconds and you want it in K/min

pls take care with temperature and absolute values, COMSOL uses Kelvin by default, even if the slop of degC and K are the same, it might be translted differently, depending on how you use your variables. The easiest is to work in SI and Kelvins

--
Good luck
Ivar
Hi I believe something like T=T0+2[K]/(60[s])*t should work better (assuming T0 has units of Kelvin) if you have left the time in the default "seconds" units. 2*t has units of seconds and you want it in K/min pls take care with temperature and absolute values, COMSOL uses Kelvin by default, even if the slop of degC and K are the same, it might be translted differently, depending on how you use your variables. The easiest is to work in SI and Kelvins -- Good luck Ivar
Frank Thomson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年5月8日 GMT-4 13:05
Thanks for the quick answer!!

will try it tomorrow right away
Thanks for the quick answer!! will try it tomorrow right away
Frank Thomson
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年5月9日 GMT-4 03:01
It is working. Did it as follows:
Global definitions:
T0=293K
T1=400K
t=0[s]

Variables
Temp T0+2[K]/(60[s])*t

Heat Transfer:
Temperature : if(Temp<T1,Temp,T1)


It is working. Did it as follows: Global definitions: T0=293K T1=400K t=0[s] Variables Temp T0+2[K]/(60[s])*t Heat Transfer: Temperature : if(Temp

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content