Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Multiple step simulation not confining to geometry

Posted 2021年3月31日 GMT-4 12:41 Structural & Acoustics, Heat Transfer, Geometry, Introduction, Mesh, Parameters, Variables, & Functions, Results & Visualization, Studies & Solvers, Structural Mechanics, Equation-Based Modeling 4 Replies

Nicholas Boechler
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,

I am running a multiple step beam simulation that has several stationary steps followed by a time-dependent step. During the stationary steps, the beam retains its shape however during the time-dependent step it does not. Does anyone have suggestions as to why this is the case? I have attached images and the file to this post.

4 Replies Last Post 2021年4月9日 GMT-4 08:31
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年3月31日 GMT-4 16:07

Nicholas,

might be a visualization effect. Have you checked the scaling in the deformation subnode?

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Nicholas, might be a visualization effect. Have you checked the scaling in the deformation subnode? Cheers Edgar
Nicholas Boechler
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年4月1日 GMT-4 13:30

I am relatively new with COMSOL, where can I find the deformation subnode? The only "scaling" term I can find is in the dependent variables in the solver settings.

I am relatively new with COMSOL, where can I find the deformation subnode? The only "scaling" term I can find is in the dependent variables in the solver settings.
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年4月2日 GMT-4 04:12
Updated: 4 years ago 2021年4月2日 GMT-4 04:16

It is a subnode in many plot types. Do a right click on the plot node to see it. Often the automatic scaling is not appropriate.

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
It is a subnode in many plot types. Do a right click on the plot node to see it. Often the automatic scaling is not appropriate.
Nicholas Boechler
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 4 years ago 2021年4月9日 GMT-4 08:31

Thank you! That was it.

Thank you! That was it.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content