Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Fixed Temperature Boundary Condition
Posted 2012年5月22日 GMT-4 11:31 Fluid & Heat, Heat Transfer & Phase Change 1 Reply
Please login with a confirmed email address before reporting spam
Hello, I'm new to COMSOL and am trying to run a non-isothermal flow problem where I have basically a rectangular solid object immersed in a volume of air flowing across the object. I placed a fixed temperature boundary condition on one of the sides of the rectangle, a temperature and velocity boundary condition on the inlet and a pressure boundary condition on the outlet. What I'm trying to accomplish is to determine the heat loss from the object to the air (without radiation for the time being). After I run the scenario, I plot the temperature and to my surprise the temperature on the wall that I placed the fixed boundary condition on is somehow lower than the fixed value I applied. What have I done wrong, or is there something else I need to do to the model?
Thanks
Thanks
1 Reply Last Post 2012年5月22日 GMT-4 11:47
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
how much is "somewhat lower" in % or other values. nad how do you define the value ? an average ...
If you are running a time series its easy to get numerical errors from too coarse mesh and to short time steps relative to the material properties
--
Good luck
Ivar
how much is "somewhat lower" in % or other values. nad how do you define the value ? an average ...
If you are running a time series its easy to get numerical errors from too coarse mesh and to short time steps relative to the material properties
--
Good luck
Ivar