Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Ill-conditioned preconditioner.
Posted 2012年6月14日 GMT-4 09:51 2 Replies
Please login with a confirmed email address before reporting spam
Hello,
I started working with this software a few days ago, I have watched and read many tutorials. I am now simulating an oversimplified version of another project but when I try to compute the solution I always get the same error
"Ill-conditioned preconditioner Increase factor in error estimate to... " I am not sure what I am doing wrong since its a very simple geometry and very simple conjugate heat transfer problem.
Help on this will be kindly appreciated.
thank you
I started working with this software a few days ago, I have watched and read many tutorials. I am now simulating an oversimplified version of another project but when I try to compute the solution I always get the same error
"Ill-conditioned preconditioner Increase factor in error estimate to... " I am not sure what I am doing wrong since its a very simple geometry and very simple conjugate heat transfer problem.
Help on this will be kindly appreciated.
thank you
Attachments:
2 Replies Last Post 2012年6月18日 GMT-4 09:23
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
if I were you, I would remove the Heat transfer in Fluid module (delete), then switch the main NITF node from heat transfer in solid to heat transfer in fluid (as master model), then add a Domain Heat transfer in Solid node and select your solid "2"
Then use a normal or finer mesh
--
Good luck
Ivar
if I were you, I would remove the Heat transfer in Fluid module (delete), then switch the main NITF node from heat transfer in solid to heat transfer in fluid (as master model), then add a Domain Heat transfer in Solid node and select your solid "2"
Then use a normal or finer mesh
--
Good luck
Ivar
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Thank you very much.