Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to model a frequency multiplying waveguide

Posted 2021年8月17日 GMT-4 04:38 RF & Microwave Engineering 1 Reply

Yotam Schatzberg
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I want to simulate a rectangular waveguide that becomes smaller along the Z axes. input signal is in frequency 100 GHz I want to measure how much power is transfered to Fout = 2Fin. is that possible? if so, how?

1 Reply Last Post 2021年8月17日 GMT-4 05:32
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年8月17日 GMT-4 05:32

Yotam,

you need some nonlinear material or a nonlinear lumped element (e.g. a diode) in the setup. If this is the case you need to run a time dependent study. Just tapering the waveguide will not produce frequency doubling.

Cheers Edgar

-------------------
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Yotam, you need some nonlinear material or a nonlinear lumped element (e.g. a diode) in the setup. If this is the case you need to run a time dependent study. Just tapering the waveguide will not produce frequency doubling. Cheers Edgar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content