Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Time explicit pressure acoustics difficulties

Posted 2021年9月9日 GMT-4 10:16 Acoustics & Vibrations Version 5.6 1 Reply

Tonni Franke Johansen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to use the Time explicit pressure acoustics (coupled to Time explicit elastic wave) I have absorbing layers surrounding the model and get the below error message from Comsol. Anyone have a clue what Comsol want to communicate? It is difficult to identify the expression pate.imp1.g_p The boundaries are the outer boundaries of the pressure acoustics absorbing layer, where I have pate.rho*pate.c as impedance.

Undefined value found in discontinuous Galerkin formulation. -Geometry:geom1 -Boundaries:28, 30, 32, 37, 42-44 -Expression:comp1.pate.imp1.g_p

1 Reply Last Post 2021年9月13日 GMT-4 06:36
Kirill Shaposhnikov COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 3 years ago 2021年9月13日 GMT-4 06:36

Hi Tonni,

It is a typical and not at all informative error message which sometimes comes up when using time explicit solvers. What it means is that the solution has grown exponentially at some mesh element and exceeded the max double value. It can be due to a mismatch in the spatial and temporal resolution of the model, which basically means the time step was to large to obey the CFL-condition.

Unfortunately, I cannot say more without seeing you model. Could you please contact support and ask them to assign the case to me?

Best regards Kirill

Hi Tonni, It is a typical and not at all informative error message which sometimes comes up when using time explicit solvers. What it means is that the solution has grown exponentially at some mesh element and exceeded the max double value. It can be due to a mismatch in the spatial and temporal resolution of the model, which basically means the time step was to large to obey the CFL-condition. Unfortunately, I cannot say more without seeing you model. Could you please contact support and ask them to assign the case to me? Best regards Kirill

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content