Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

regarding capacitance of two square plates diaphragm made of silicon

Please login with a confirmed email address before reporting spam

how can i find the capacitance of two parallel square plates?
please tell the modules to be used in 3.5 a version.
in this case one plate is fixed(lower) & the four sides of upper plate is fixed which act as diapragm.
in 3.5a version, the capacitance is not defined in the predefined quantites, in electrostatics module.....
then how can i find the capacitance.................???????????


1 Reply Last Post 2012年8月3日 GMT-4 04:47
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年8月3日 GMT-4 04:47
Hi

what about checking the doc and the model library, there are a fwe eaxmples therein, with step by step instructions. Not to say, try a search on the FORUM, uder 3.5a

--
Good luck
Ivar
Hi what about checking the doc and the model library, there are a fwe eaxmples therein, with step by step instructions. Not to say, try a search on the FORUM, uder 3.5a -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.