Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Problem with defining boundaries conditions and physical properties

Please login with a confirmed email address before reporting spam

Good morning,

I am a new userof comsol.

I have a problem with the definition of boundaries conditions in the attached model.
I make some solid blocks and join them to have one object. The idea is to define each object with its own physical property.

When i click on the boundary mode, i receive this message: "Error: 2100
Internal error in geometry decomposition."

And it is a same message for physics/subdomain settings or boundaries settings.

Perhaps i have some problems when i make the union of blocks, but i don't have any message at this time.
I don't know.

Another question: how can i make a disunity of these blocks?

Thanks you.
HAve a nice day.


0 Replies Last Post 2010年2月6日 GMT-5 17:09
COMSOL Moderator

Hello Linda Nz

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.