Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Add parameter to parametric sweep after Parametric Solution already exists

Please login with a confirmed email address before reporting spam

The below post is related to an archived discussion


Hello,

I have the same question as in the unanswered discussion above.

Suppose I have solved a parametric sweep simulation over the variable a = (1,3,5).

After checking my results, I want to add the parameters a = (2,4) to my sweep without resolving the existing solutions (1,3,5). Is there an easy way to do this?

My work-around is to create a second parametric sweep that contains only the new parameter setup, and later merge the two solutions. But this is a tedious process.

Thanks a lot for your help!


0 Replies Last Post 2022年10月6日 GMT-4 08:53
COMSOL Moderator

Hello Julius Harms

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.