Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

1D elements in 3D analysis

Posted 2022年10月19日 GMT-4 07:45 Fluid & Heat, Mesh 2 Replies

Ruben D'Rose
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I have a cylinder of some solid material with a narrow central channel filled with presumably a fluid. The channel, connected to the "outside", transports heat and species to and from the solid by diffusion.

The channel is narrow and I am not interested in the temperature and concentration profiles over the cross-section of the channel. Using 1D elements would greatly reduce the mesh complexity. I think Ansys has such a feature. Is there a similar thing for COMSOL?

2 Replies Last Post 2022年10月24日 GMT-4 10:16
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 2022年10月20日 GMT-4 13:46

Hello Ruben,

Yes, you are describing the Pipe Flow Module!

Best,

Jeff

-------------------
Jeff Hiller
Hello Ruben, Yes, you are describing the [Pipe Flow Module](https://www.comsol.com/pipe-flow-module)! Best, Jeff
Ruben D'Rose
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 2 years ago 2022年10月24日 GMT-4 10:16

Thanks Jeff! I will definitely look into it.

Regards, Ruben

Thanks Jeff! I will definitely look into it. Regards, Ruben

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content