Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Where should I put constraint
Posted 2012年10月19日 GMT-4 07:12 1 Reply
Please login with a confirmed email address before reporting spam
Hi All,
I'm not sure where I should put constraint or maybe I should use prescribed displacement in my model?
My model (in attachment):
I calculate the stationary state then I use stationary calculations as initial conditions for time depending study and I changed heat transfer coefficient because I assumed that steel surface starts to be cooled by water. But my thermal stresses looks falsely.
Should I use first principal stress or von Mises stress in presentation of results?
Why I get a negative value of stress?
Thank you for any insight,
Robert
I'm not sure where I should put constraint or maybe I should use prescribed displacement in my model?
My model (in attachment):
I calculate the stationary state then I use stationary calculations as initial conditions for time depending study and I changed heat transfer coefficient because I assumed that steel surface starts to be cooled by water. But my thermal stresses looks falsely.
Should I use first principal stress or von Mises stress in presentation of results?
Why I get a negative value of stress?
Thank you for any insight,
Robert
Attachments:
1 Reply Last Post 2012年10月19日 GMT-4 09:21
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
I suppose the effect comes from the Roller condition in the middle of the model, I would haver expected that condition on Boundary "5"
then use rather a time stepping of the type: as heat diffusion has a nice decay
2^{range(-1,0.5,10)}
then your slot is not really physical, as with these temperature the two bricks will exchange heat, but that is probably OK as a first approach
As I cannot really understand what is fixed and what is rigid here it's difficult to suggest something
--
Good luck
Ivar
I suppose the effect comes from the Roller condition in the middle of the model, I would haver expected that condition on Boundary "5"
then use rather a time stepping of the type: as heat diffusion has a nice decay
2^{range(-1,0.5,10)}
then your slot is not really physical, as with these temperature the two bricks will exchange heat, but that is probably OK as a first approach
As I cannot really understand what is fixed and what is rigid here it's difficult to suggest something
--
Good luck
Ivar