Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Loading condition

Posted 2023年5月18日 GMT-4 16:35 Geometry, Modeling Tools & Definitions, Physics Interfaces 0 Replies

Syed Baqir Kazmi
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hey there,

I have 4 point bending setup 2D COMSOL model. I want to model 4 point bending constant deflection/strain test. I have a rectangle (substrate) and I put 2 dots on the rectange representing loading clamps and 2 dots at the outer side representing support clamps.

1) How can I add load as a Force (F) in Newtons to increase until midspan deflection reaches a certain number lets say 0.5 mm ?

2) I am trying to simulate setup as second picture, Can anyone help me with this?

I appretiate any help regarding this or perhaps if anyone have already done something similar and willing to share the model?

Thank you.

0 Replies Last Post 2023年5月18日 GMT-4 16:35
COMSOL Moderator

Hello Syed Baqir Kazmi

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content