Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Problem with multislice view
Posted 2012年11月5日 GMT-5 06:16 RF & Microwave Engineering Version 4.3 0 Replies
Please login with a confirmed email address before reporting spam
I'm new in COMSOL and RF modeling so I started with building existing models from model gallery by following given instructions. At the moment I'm simulating model Biconical Antenna.
The results (S-parameters) I got are correct, but multislice view is what actually bothers me. The picture of multislice views are in attachment. When i simulate existing model (from models\RF_Module\RF_and_Microwave_Engineering) I get multislice view on the left, but when I simulate model that I made by following the instructions, I get multislice view on the right. I've tried to find difference in result settings, but I couldn't find one.
Did I make some mistake and how could I correct it?
Best regards,
Josip
Attachments:
Hello Josip Loncar
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.