Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Boundary selection error

Please login with a confirmed email address before reporting spam

In heat transfer in solid and fluid section i could not chosse manual boundary selection under phase change interface. Generally i want to select only boundary 6 and it shows boundary is overridden. How can i get rid of this problem?

And how can I find the phase change curve?

Can you please help me out. My project work is stooped due to this problem.

Password: 123



2 Replies Last Post 2023年8月9日 GMT-4 17:25
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 2023年8月9日 GMT-4 12:23

Hello Gourav,

You attached the mph.lock file; it's the mph file that would allow users of this Forum to see your model and hopefully make recommendations.

Best,

Jeff

-------------------
Jeff Hiller
Hello Gourav, You attached the mph.lock file; it's the mph file that would allow users of this Forum to see your model and hopefully make recommendations. Best, Jeff

Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 year ago 2023年8月9日 GMT-4 17:25

Now you've attached the wrong screenshots.

Jeff

-------------------
Jeff Hiller
Now you've attached the wrong screenshots. Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.