Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to model residual thin film stresses as a boundary condition

Posted 2012年11月23日 GMT-5 03:32 MEMS & Nanotechnology, MEMS & Piezoelectric Devices Version 4.2a 3 Replies

Christian Dahl-Petersen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi Forum,

I'm trying to model a thin Nitride film on top of a "thicker" silicon membrane, however, I cannot seem to find the right way of modelling the initial (tensile in-plane) stress in the thin film. Tried the Boundary load boundary conditions but it does not seem to produce the right results.

Best Regards
Christain
3 Replies Last Post 2012年11月26日 GMT-5 00:52
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年11月23日 GMT-5 07:45
Hi

My way is to use temperature induced stress (as othen the stress is build up like that), see the model library example

--
Good luck
Ivar
Hi My way is to use temperature induced stress (as othen the stress is build up like that), see the model library example -- Good luck Ivar
Christian Dahl-Petersen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年11月24日 GMT-5 14:24
Hmm, my problem is that its not thermally build stress (well to be true it is thermally build, however, that is before the modelled device is made). So i need to apply it somehow as a boundary in order not to mesh the verythin film. Isnt that possible in COMSOL...?
Hmm, my problem is that its not thermally build stress (well to be true it is thermally build, however, that is before the modelled device is made). So i need to apply it somehow as a boundary in order not to mesh the verythin film. Isnt that possible in COMSOL...?
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2012年11月26日 GMT-5 00:52
Hi

have you checked the model library layered_plate ? For me this is the cleanest way to get a full stress tensor correctly aligned

--
Good luck
Ivar
Hi have you checked the model library layered_plate ? For me this is the cleanest way to get a full stress tensor correctly aligned -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content