Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Thermo-mechanical simulation injection molding
Posted 2010年2月22日 GMT-5 06:07 0 Replies
Please login with a confirmed email address before reporting spam
I'm trying to simulate the stress of a duroplast part coated in thermoplast. Therefore I set the strain reference temperature to 240°C (process temperature, injection molding) and cooled the part down to 25°C. The problem is that the stress is way too high on many areas (about 2000 MPa, while thermoplast breaks at 210MPa).
The thermoplast I use is Polyamide 66 with 35% glass fibre reinforcement.
What mistakes did I made in my model? If the stress were always high like this, no thermoplastic part would work after injection molding.
Hello Christoph Gl.
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.