Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Geometry visualization
Posted 2013年1月14日 GMT-5 09:40 Low-Frequency Electromagnetics, Mesh Version 4.2a 1 Reply
Please login with a confirmed email address before reporting spam
Hi all,
I have a comlex geometry in 3D, which is not suitable for simplification. I have to model a wire of a coil together witz its insulation. The wire has a dimension of some mm while the insulation is 0.2mm. The total dimension of the model is about 400 mm. Now I get errors during meshing, including selfintesecting boundaries.Is there a (easy) way to find these "error" boundaries? Or is it possible in preprocessing, to cut the model and see only the geometry on this cutplane.?
Does anybody has some suggestions
Thanks
Uwe
I have a comlex geometry in 3D, which is not suitable for simplification. I have to model a wire of a coil together witz its insulation. The wire has a dimension of some mm while the insulation is 0.2mm. The total dimension of the model is about 400 mm. Now I get errors during meshing, including selfintesecting boundaries.Is there a (easy) way to find these "error" boundaries? Or is it possible in preprocessing, to cut the model and see only the geometry on this cutplane.?
Does anybody has some suggestions
Thanks
Uwe
1 Reply Last Post 2013年1月15日 GMT-5 00:48
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
it's often useful to cut a geometry, i.e. through 1-3 planes, and if you have some symmetry, manually mesh using this local symmetry
--
Good luck
Ivar
it's often useful to cut a geometry, i.e. through 1-3 planes, and if you have some symmetry, manually mesh using this local symmetry
--
Good luck
Ivar