Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Heat Transfer in Fins- Help needed

Posted 2013年1月20日 GMT-5 09:26 Heat Transfer & Phase Change, Computational Fluid Dynamics (CFD) Version 4.2a 1 Reply

Sathyanarayanan Nagasundaram
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am trying to simulate a heat sink, very similar to the one shown in the tutorials... In spite of building a coarse mesh, the solution does'nt converge even after 2 hours of solving. I have an i5 processor and a 4 gb ram. I would like to know which solver and which configuration are best to solve my steady state heat transfer problem.

Thanking you,
N.Sathyanarayanan
1 Reply Last Post 2013年1月20日 GMT-5 13:26
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年1月20日 GMT-5 13:26
Hi

CFD with only 4 Gb of RAM is a challenge, a too coarse mesh cannot resolve any turbulent behaviour, at least not in 3D, so there can be several reasons, such as mesh to coarse, mesh quality (boundary mesh ..) often its worth to use the analytical fprmulas for convecting coolign of horizontal or vertical boundaries, rahter to solve the heat convective equation fully in CFD mode

--
Good luck
Ivar
Hi CFD with only 4 Gb of RAM is a challenge, a too coarse mesh cannot resolve any turbulent behaviour, at least not in 3D, so there can be several reasons, such as mesh to coarse, mesh quality (boundary mesh ..) often its worth to use the analytical fprmulas for convecting coolign of horizontal or vertical boundaries, rahter to solve the heat convective equation fully in CFD mode -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content