Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Fluidic Chamber Design

Posted 2025年1月30日 GMT+8 02:10 General, Geometry 1 Reply

Hashem Nasralla
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I have an Inlet in the form of a cylinder of radius 0.5mm. I need to tapper it so that that it at the bottom becomes a rectangle of length 1mm and height 0.1mm. How can I build this geometry? Thanks

1 Reply Last Post 2025年1月30日 GMT+8 02:20
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 7 months ago 2025年1月30日 GMT+8 02:20
Updated: 7 months ago 2025年1月30日 GMT+8 02:20

Hello Hashem,

Use the Loft feature. It is available in the optional Design Module. To determine if the license you are using includes the Design Module, look undet File > Licensed and Used Products.

Best,

Jeff

-------------------
Jeff Hiller
Hello Hashem, Use the Loft feature. It is available in the optional [Design Module](https://www.comsol.com/design-module). To determine if the license you are using includes the Design Module, look undet File > Licensed and Used Products. Best, Jeff

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content