Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
physical settings of high-frequency electrode design
Posted 2025年4月10日 GMT+8 15:46 Electromagnetics, RF & Microwave Engineering Version 6.3 0 Replies
Please login with a confirmed email address before reporting spam
Hello,
I am designing a component with high-frequency GS electrodes (~50 GHz) in RF module.
As shown in the attached figure, I would like to simulate the probe connected above the Pads. Currently, I am using a Lumped Port (Uniform) design placed between two TBC and located at the center cross-section of the Pad. The outermost boundary of the simulation region is set with SBC. I would like to know if the setup is correct or if there are areas that need improvement (including physics, mesh & study).
My explanation may not be detailed enough, but you can refer to the attachment for more information.
Best regards,
Attachments:
Hello Larry Lai
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.