Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
boundary layer meshing ?
Posted 2013年3月29日 GMT-4 06:28 1 Reply
Please login with a confirmed email address before reporting spam
Hello,
why is the boundary meshing interrupted in the corner of 2 edges?
(attached pictures)
These are the limits of my plasma reactor. The point where my electrical feedthrough is, ceramic/metal joint.
The point where all happens?).
So why is there the mesh not like a bit further away, where the boundary meshing is on both side of the edges?
in 3.5, I could prevent comsol from meshing inactiv domains.. I am doing something wrong (the inside of metals do not bother me..)
Thanks
Lukas
nagoya-u
Attachments:
1 Reply Last Post 2013年3月29日 GMT-4 07:10
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Hi
strange, it could be from some BC that turns them, off, but if the boundaries are all in the list of the boundary mesh definition they should be meshed. Probably only Support might be really able to tell here ;)
--
Good luck
Ivar
strange, it could be from some BC that turns them, off, but if the boundaries are all in the list of the boundary mesh definition they should be meshed. Probably only Support might be really able to tell here ;)
--
Good luck
Ivar