Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Part of the model is permently marked blue

Posted 2013年4月23日 GMT-4 05:45 1 Reply

Wolfgang Grzesik
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, i got some solving problems and actually im trying to fix the problem. It is strange that a part of my model is permently marked blue after meshing. What could this be?

Thanks!
1 Reply Last Post 2013年4月23日 GMT-4 06:05
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年4月23日 GMT-4 06:05
Hi

the blue means that there is somewhere an active selection that has remained, you can either click outside of your model or try a CNTR-D (unselect all, opposite to CNTRL A select all)

another possible reason is that some material changes the colour of the domains, i.e. water turn the domain blue, not to mix up with "selection blue"

--
Good luck
Ivar
Hi the blue means that there is somewhere an active selection that has remained, you can either click outside of your model or try a CNTR-D (unselect all, opposite to CNTRL A select all) another possible reason is that some material changes the colour of the domains, i.e. water turn the domain blue, not to mix up with "selection blue" -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content