Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Batch Processing sj

Please login with a confirmed email address before reporting spam

Dear Engineers/Scientists

I am trying to simulate time dependent study a diaphragm with piezo actuator fixed from its periphery and want plot Voltage Vs deflection and also frequency Vs deflection simultaneously but it is not possible for simple simulation i have go for batch processing or some other option because it is possible with ansys to write a small code and do it but In comsol i am not able to do it because i just started using comsol due its good capability to couple different field like FSI and electrical and structural etc, I will be wonder if anybody can Help me

I will very thankful

Ikhlaq Ayub

1 Reply Last Post 2013年5月2日 GMT-4 16:35
Ivar KJELBERG COMSOL Multiphysics(r) fan, retired, former "Senior Expert" at CSEM SA (CH)

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年5月2日 GMT-4 16:35
Hi

Isn't that the parametric sweep condition with 2 parameters you want ?
If so, just check correctly how you want to mix/stock the two parameters, check the help doc

--
Good luck
Ivar
Hi Isn't that the parametric sweep condition with 2 parameters you want ? If so, just check correctly how you want to mix/stock the two parameters, check the help doc -- Good luck Ivar

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.