Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Warning: Parametric solver does not support geometry and mesh dependent parameters
Posted 2013年5月30日 GMT-4 03:36 Version 5.0 1 Reply
Please login with a confirmed email address before reporting spam
I want to sweep a parameter, but the geometry and mesh depend on the parameter. Then I get the warning message
Parametric solver does not support geometry and mesh dependent parameters.
I found a related discussion thread, where Ivar replied
-------------------------------------------------------------------------
Hi
In which context did you get that error, if you have selected a Solver Continuation parametrical sweep then it is because that is NOT looping over the geoemtry and the mesh.
To perform a parametric sweep to change the geoemtry and to remesh you need to add a separate "parametric Sweep" node before your solver node
--
Good luck
Ivar
-------------------------------------------------------------------------
Does anyone know how to add the separate "parametric sweep" node?
Thanks!
Hello Pu Zhang
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
Also see
www.comsol.com/community/forums/general/thread/36089/#p189383