Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Coupling 1D Pipeflow to 2D axisymmetric Porous Media

Posted 2013年5月31日 GMT-4 13:39 Fluid & Heat, Computational Fluid Dynamics (CFD), Studies & Solvers Version 4.3a, Version 4.3b 1 Reply

Burns Cunningham
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

I am working on coupling 1D pipeflow to 2D axisymmetric porous media. The coupling is peformed by averaging the 2D boundary to the 1D point and integrating the 1D point to the 2D boundary. The coupling variables are pressure and velocity.

I have used this average and integration operator coupling approach with 1D pipeflow to 3D k-epsilon coupling before with success.

When the model is run, the solution oscillates continuously but never converges. Plotting results while solving shows that there is an issue at the porous media inlet. The porous media inlet condition is based on integrating the pipeflow velocity at that point to the 2D inlet. Flow is not entering and passing through the porous media section like it should, and I'm not sure why that is. My model is attached. Any suggestions on how to fix this boundary inlet condition would be appreciated.

Thanks,

Burns

Attachments:

1 Reply Last Post 2014年2月18日 GMT-5 12:05
COMSOL Moderator

Hello Burns Cunningham

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Jamie Trahan
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年2月18日 GMT-5 12:05
Hello,

I am having a similar problem where the 1D flow is not entering my 2D porous bed. Did you find a way to solve this problem?

Thank you,
Jamie
Hello, I am having a similar problem where the 1D flow is not entering my 2D porous bed. Did you find a way to solve this problem? Thank you, Jamie

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content