Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

how to show the error curve

Posted 2013年8月13日 GMT-4 23:00 Results & Visualization, Studies & Solvers Version 4.3b 1 Reply

Jiuan Wei
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi All,

Normally there is an error curve to show the convegence speed when running a case. However, I closed some windon in Graphic and this error curve is not shown. Wihout this curve, I am not able to know when this case will be converged.

Can you please tell me how to show the error curve? Thansk.

Regards,

Jiuan
1 Reply Last Post 2013年8月14日 GMT-4 17:48
Josh Thomas Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年8月14日 GMT-4 17:48
Jiuan,

Try the little icon above the Progress tab. This should work for you.

Best regards,
Josh Thomas
AltaSim Technologies
Jiuan, Try the little icon above the Progress tab. This should work for you. Best regards, Josh Thomas AltaSim Technologies

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content