Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

How to make a vacuum chamber in a capacitor?

Posted 2013年9月17日 GMT-4 09:18 MEMS & Nanotechnology, MEMS & Piezoelectric Devices, Materials, Structural Mechanics Version 4.2, Version 4.2a, Version 4.3, Version 4.3a 3 Replies

Yu Y.Y
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi, I am trying to model a MEMS capacitor built on the silicon substrate. The thin top plate(membrane) of the capacitor is also made of silicon. The gap between the plates is vacuum sealed. So with zero bias voltage on the capacitor, this thin top plate (membrane) is deflected to the bottom substrate due to the surrounding air pressure. I don't konw how to make the vacuum chamber in the device to model the deflection. Emi physics is used in modeling.
Any suggestions is appreciated!
3 Replies Last Post 2013年9月20日 GMT-4 06:34
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年9月19日 GMT-4 09:35
Hi,

it is not the vacuum deflecting the membrane, it is the atmospheric pressure. Can't you apply a pressure BC to the outside of the membrane?

Cheers
Edgar

--
Edgar J. Kaiser
emPhys Physical Technology
Hi, it is not the vacuum deflecting the membrane, it is the atmospheric pressure. Can't you apply a pressure BC to the outside of the membrane? Cheers Edgar -- Edgar J. Kaiser emPhys Physical Technology
Yu Y.Y
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年9月20日 GMT-4 05:33
Hi,Edgar
Thank you for your solution! It is a good way to apply the atmospheric pressure as the BC on the membrane to model the deflection. However, the membrane will vibrate by the AC voltage applied on the capacitor. What I am not certained is that the air in the gap may act as the air cushion, which damps the vibration. I want to eliminate the damping caused by the air inside the gap.
Hi,Edgar Thank you for your solution! It is a good way to apply the atmospheric pressure as the BC on the membrane to model the deflection. However, the membrane will vibrate by the AC voltage applied on the capacitor. What I am not certained is that the air in the gap may act as the air cushion, which damps the vibration. I want to eliminate the damping caused by the air inside the gap.
Edgar J. Kaiser Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2013年9月20日 GMT-4 06:34
Well, I don't have the MEMS module and you were asking about deflection not about damping. Maybe one of the MEMS experts can help ...?

Cheers
Edgar

--
Edgar J. Kaiser
emPhys Physical Technology
Well, I don't have the MEMS module and you were asking about deflection not about damping. Maybe one of the MEMS experts can help ...? Cheers Edgar -- Edgar J. Kaiser emPhys Physical Technology

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content