Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Advice to study a borehole system behaviour. (4.3b)

Posted 2013年10月24日 GMT-4 08:10 Fluid & Heat, Heat Transfer & Phase Change Version 4.3b 0 Replies

Jordi J M
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi,
I am a beginner with Comsol, and I am studying a heat exchange borehole system.

I want to consider the heat flux coming from the ground, the transfer between the pipe inside and the filling liquid inside the borehole. But I think that first it would be better simulate only the transfer between borehole and ground without pipe inside.

My question is how I can simulate that the heat flux is coming from the top, the liquid that flow going down?
I just simulated with a uniform heat flux, in the borehole surface.

If I am wrong, could you tell me the correct steps to a realistic simulation.

Thanks for your help.
0 Replies Last Post 2013年10月24日 GMT-4 08:10
COMSOL Moderator

Hello Jordi J M

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content