Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
No change in laminar flow simulation results even after changing material properties like Dynamic viscosity and Density.
Posted 2013年11月22日 GMT+8 14:05 Fluid & Heat Version 4.3b 4 Replies
Please login with a confirmed email address before reporting spam
I have been doing very straight-forward and simple laminar flow simulations in a chamber. I have observed that flow simulation results don't change if I add and use another fluid with different dynamic viscosity and density. I tried varying the viscosity values but I couldn't notice any change in velocity gradients. I don't fully trust my results because of this reason.
Also, I would not be able to run these flow simulations if I don't mention at least dynamic viscosity and density of the fluid.
Thank you for having a look.
Best,
Vishal
Please login with a confirmed email address before reporting spam
Is it possible for you to upload your model, so I/we can have a look at it?
Best regards
Mikael
Please login with a confirmed email address before reporting spam
Thanks. I am afraid to say that having trouble attaching the model file, I always get the "File size error" message. My minimum file size is 5.93 MB. It would be great if you could suggest me some way to make it available to you. Thanks.
Anyway, after delving into basics of Fluid Mechanics I realized that fluid velocity would hardly depend on the viscosity of the fluid for a given flow rate and geometry. My model is pretty simple: Its a chamber of 20 x 20 x 2 mm^3 dimensions connected to 4 channels of hydraulic diameter of 0.8 mm on all four sides. I am simulating 90 degree flow configuration. Please find the image attached for better understanding.
Currently, my sole problem is that my velocity prediction in different parts of chamber using simulation doesn't really match with my Particle Image Velocimetry (PIV) experiments. I am confident that my PIV results are accurate and reproducible which are cross-checked using alternate methods. There is approximately on an average 76% deviation of COMSOL results from PIV results. The velocity values given by COMSOL are much lesser than that given by PIV.
Moreover, the velocity values don't change much with the change in Mesh size. I understand without model file nothing can be said and done much.
Tak,
Vishal
Attachments:
Please login with a confirmed email address before reporting spam
I have deleted mesh, solutions and study (Stationary) to make the file size very small. Thanks a lot for the suggestion, it worked. Please find the file attached here.
Thank you.
Best,
Vishal
Attachments:
Please login with a confirmed email address before reporting spam
Did you figure out the answer for this question? Why are simulation results same even after changing the viscosity of fluid?
Aisha