Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Parametric Sweeping a Geometrical Parameter! Possible?

Please login with a confirmed email address before reporting spam

I have a polymer coil in a solid cylinder. This is a reaction-diffusion model. I think usually the materials property or other similar non-geometrical properties are sweeped in parameter sweep.

I want to vary the coil's diameter in parameter sweep. Is this possible? Whats the protocol for meshing for doing this?

2 Replies Last Post 2014年3月28日 GMT-4 00:39
Jeff Hiller COMSOL Employee

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年3月27日 GMT-4 14:50
Yes. See www.comsol.com/community/forums/general/thread/38787/ .
Best,
Jeff
Yes. See http://www.comsol.com/community/forums/general/thread/38787/ . Best, Jeff

Please login with a confirmed email address before reporting spam

Posted: 1 decade ago 2014年3月28日 GMT-4 00:39

Yes. See www.comsol.com/community/forums/general/thread/38787/ .
Best,
Jeff


Thanks a lot!
I tried doing it. Though I ended up with nonlinear solver did not convergence. Any idea how to troubleshoot this error?

Appreciate the help!

[QUOTE] Yes. See http://www.comsol.com/community/forums/general/thread/38787/ . Best, Jeff [/QUOTE] Thanks a lot! I tried doing it. Though I ended up with nonlinear solver did not convergence. Any idea how to troubleshoot this error? Appreciate the help!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.