Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Symmetry in General Form PDE module

Please login with a confirmed email address before reporting spam

Hello,

I am trying to simulate, let's say, two turns of the coil (current is flowing the same direction in both turns) in 2D case using a General Form PDE module. I have only copper windings surrounded by air. Instead of doing that, I would like to simulate only one turn (half of the model) because it is a symmetric case and simulation would be much faster. I do not know how to implement/use this symmetry in PDE module. Any suggestions?

1 Reply Last Post 2015年9月28日 GMT-4 10:33
COMSOL Moderator

Hello Rokas Bondzinskas

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.


Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年9月28日 GMT-4 10:33
Hi,
I encountered the same issue. Did you solve it ?
Thank you,
Mhrz
Hi, I encountered the same issue. Did you solve it ? Thank you, Mhrz

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.