Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Successive simulation in COMSOL 4.3

Posted 2014年5月10日 GMT-4 06:06 Fluid & Heat, General, Computational Fluid Dynamics (CFD), Microfluidics, Mesh, Studies & Solvers Version 4.3 0 Replies

Dániel Kovács
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello everybody!
I am curently doing simulations of fluid flows in microfluidic channels. The total simulation domain is quite big and a mesh that could provide a solution with resonable precision would take too much memory.

Can I somehow partition the simulation domain so that I run computation only on a part of it and when it is done I use the outlet data as input to the next channel section and run the simulation on this section only, etc.? If yes, how? Has anyone experience with such tricks?

Thanks in advance,
Daniel
0 Replies Last Post 2014年5月10日 GMT-4 06:06
COMSOL Moderator

Hello Dániel Kovács

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content