Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

I vs U component: is the resistance included?

Posted 2014年6月29日 GMT-4 08:18 Low-Frequency Electromagnetics Version 4.4 1 Reply

Minh Khoa Nguyen
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

In my model of an induction motor, the stator slots are modeled by Multi-Turn Coil domain with Coil excitation as Circuit (current).
In the power supply circuit, I use I vs U component for the coupling. I wonder if I must add a resistor to model the the resistance of the coil in the circuit or I vs U component already includes that resistance?

Regards,
1 Reply Last Post 2017年4月24日 GMT-4 10:54
COMSOL Moderator

Hello Minh Khoa Nguyen

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

David Giglio
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Posted: 7 years ago 2017年4月24日 GMT-4 10:54
Hi. I have the same question. I wish someone would answer this. I am modelling a 3D transformer and have studied the e-core transformer model from the applications gallery which uses a primary and secondary resistances to represent the winding resistances . If I do not put a resistor in series with the I vs U component then I get an error. If it is necessary to use a resistor then I wish the help documents would mention and emphasize this.
Hi. I have the same question. I wish someone would answer this. I am modelling a 3D transformer and have studied the e-core transformer model from the applications gallery which uses a primary and secondary resistances to represent the winding resistances . If I do not put a resistor in series with the I vs U component then I get an error. If it is necessary to use a resistor then I wish the help documents would mention and emphasize this.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content