Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.
Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
Surface conductivity in RF module
Posted 2014年10月30日 GMT-4 06:53 RF & Microwave Engineering Version 4.4 1 Reply
Please login with a confirmed email address before reporting spam
Hi all,
I am calculating the mode profiles and effective indices a dielectric waveguide using the Frequency Domain module. I was wondering if it is possible to introduce a surface with a specific surface conductivity within my model.
Thanks,
Koen
I am calculating the mode profiles and effective indices a dielectric waveguide using the Frequency Domain module. I was wondering if it is possible to introduce a surface with a specific surface conductivity within my model.
Thanks,
Koen
1 Reply Last Post 2014年10月31日 GMT-4 09:14
Please login with a confirmed email address before reporting spam
Posted:
1 decade ago
Koen,
1. There is Impedance Boundary Condition you can use on EXTERIOR boundaries to represent the surface of lossy domain. The material properties in this BC are for the domain outside the boundary not inside.
2. There is Transition Boundary Condition you can use on INTERIOR boundaries to model thin layer with the specified material properties (conductivity, permittivity, and permeability) and given thickness of the layer. Mathematically this BC describes a relation between the electric field discontinuity across the layer and the induced surface current density.
Note that both these boundary conditions are not available with the Transient Electromagnetic Waves interface.
Regards,
Sergei
1. There is Impedance Boundary Condition you can use on EXTERIOR boundaries to represent the surface of lossy domain. The material properties in this BC are for the domain outside the boundary not inside.
2. There is Transition Boundary Condition you can use on INTERIOR boundaries to model thin layer with the specified material properties (conductivity, permittivity, and permeability) and given thickness of the layer. Mathematically this BC describes a relation between the electric field discontinuity across the layer and the induced surface current density.
Note that both these boundary conditions are not available with the Transient Electromagnetic Waves interface.
Regards,
Sergei