Menu

Discussion Forum

New Discussion
查找

Note: This discussion is about an older version of the COMSOL Multiphysics® software. The information provided may be out of date.

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Simulating a biomedical stent: problem with the surfaces.

Posted 2015年3月4日 GMT-5 02:57 Geometry, Mesh, Structural Mechanics Version 4.4 0 Replies

Certified Consultant
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hello,

I am trying to do some mechanical simulations of a stent, which I designed with Solidworks. The peorblem is that I used (with Solidworks) the following process: design-extrude-wrap around a cylinder and the warping didn't lead to an EXACT closure of the top and bottom surface; there is a gap between them (as seen in the picture attached).

This gap leads to meshing issuses in COMSOL. Do you know how could I use COMSOL to close it, or if there are any virtual operations for that.

Thank you very much in advance!

Attachments:

0 Replies Last Post 2015年3月4日 GMT-5 02:57
COMSOL Moderator

Hello

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content