Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Reached singularity when I use open boundary conditions

Please login with a confirmed email address before reporting spam

I am currently using the laminar flow module in my log drying simulation. The goal is to see how windspeed effects heat transfer in open air.
When the Top and bottom of the domais are walls, the model seems to work just fine. However, when I change them to open boundary conditions I get, the error,
Repeated error test failures. May have reached a singularity
Last time step is not converged.
I only get this error when they are open boundary conditions.

I am not sure why. I know that the top and bottom will not be walls in nature since this is wind outside.
The windspeed is from an interpolated function, obtained from data from a weather station


0 Replies Last Post 2015年4月9日 GMT-4 22:06
COMSOL Moderator

Hello David Harris

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.