Menu

Discussion Forum

New Discussion
查找

Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Solving

Posted 2010年7月20日 GMT-4 16:27 0 Replies

Pekir Joseph
Send Private Message Flag post as spam

Please login with a confirmed email address before reporting spam

Hi:

I have a 3D model that runs and solves a parametric sweep without any problems,
but when I run this same model in comsol 4.0 its run but gets stuck in the middle around (Constraint Handling)
What might be the cause of this?

Best Regards
Pekir
0 Replies Last Post 2010年7月20日 GMT-4 16:27
COMSOL Moderator

Hello Pekir Joseph

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.

Suggested Content