Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

A basic formula change

Please login with a confirmed email address before reporting spam

Hi,
I use COMSOL Multiphysics 3.5 Heat Transfer, Convection and Conduction, Steady-States Analysis to describe the temperature gradient around a thin wire. I want to change the standard formula used in COMSOL with other one that is using in this case. How can I do it?
Thanks in advance!
Mitko

2 Replies Last Post 2009年9月15日 GMT-4 03:13

Please login with a confirmed email address before reporting spam

Posted: 2 decades ago 2009年9月15日 GMT-4 01:17
To do so, you can go to physics -> Equation Systems, and then choose subdomain, boundary, or point (depending on what you want to do). In there you will find all the relevant equations. You can modify any of these.

Hope this helps.
To do so, you can go to physics -> Equation Systems, and then choose subdomain, boundary, or point (depending on what you want to do). In there you will find all the relevant equations. You can modify any of these. Hope this helps.

Please login with a confirmed email address before reporting spam

Posted: 2 decades ago 2009年9月15日 GMT-4 03:13
Thank you very much, Mario!
Thank you very much, Mario!

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.