Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.
3D Spiral Microfluidic Channel _Cannot increase velocity result not converge
Posted 2015年5月22日 GMT-4 11:23 1 Reply
Please login with a confirmed email address before reporting spam
I'm new to comsol and I built a 3D spiral microfluidic channel. The height and width of it are 50um, 400um respectively.
The parameters of the density and the dynamic viscosity of the fluid in the channel section are set to that of water. The equations of laminar flow used in the simulation are given by full Navier- Stokes equations for incompressible fluids.
When I increase the inlet velocity, it says "Failed to find a solution. Divergence of the linear iterations. The relative residual is more than 1000 times larger than the relative tolerance. Returned solution is not converged." The velocity can be only set up to 0.07m/s now.
Could anyone help to provide some solution?
Thank you in advance.
Hello Zheng Dai
Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.
If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.
Please login with a confirmed email address before reporting spam
I am trying to simulate two phase flowing in a spiral channel. I have done that for 2-D (a section of spiral channel) and now I am trying 3-D model. So, I just wonder whether you used comsol to draw your 3D spiral channel or another software.
Thank you in advance for you help.