Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

AC/DC transmission line capacitance

Please login with a confirmed email address before reporting spam

Good morning;

i am new to the wonderful world of Comsol;

i am busy trying to compute the capacitance (mutual) between the conductors of a 5 conductor (above earth) transmission lines. i am evaluating the capacitance between traction/high voltage cables.

the problem i have is, when i compute capacitance like the tutorials indicate (global evaluation) i get the global averaged value for capacitance. i would like to get the capacitance between two specific cables in the vicinity of all the other cables.

I have been looking at lumped parameters/ports but i must admit i am a bit lost and would greatly appreciate any help/comments/tutorials.

regards
Gerhard

0 Replies Last Post 2015年5月26日 GMT-4 03:43
COMSOL Moderator

Hello Gerhard Breedt

Your Discussion has gone 30 days without a reply. If you still need help with COMSOL and have an on-subscription license, please visit our Support Center for help.

If you do not hold an on-subscription license, you may find an answer in another Discussion or in the Knowledge Base.

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.