Discussion Closed This discussion was created more than 6 months ago and has been closed. To start a new discussion with a link back to this one, click here.

Behavior at Axis of Symmetry

Please login with a confirmed email address before reporting spam

I am simulating a 25 nm radius gold wire in a dielectric cladding. I am measuring the characteristic impedance of the mode of the wire. I have run it in both 2-D axisymmetric and in eigenmode analysis.

My question is regarding the behavior at the axis of symmetry in the axisymmetric mode. The plot should be constant inside and outside the wire, and the expected plot is shown in the eigenmode simulation. However, in the 2-d axisymmetric, I see change in the value at r = 0. Does anyone know why this occurs and how I can avoid it/if it is avoidable?

I am attaching the COMSOL simulation files and powerpoint of the plots I am talking about.

Best,
Cheng-Ming


1 Reply Last Post 2015年8月13日 GMT-4 13:40
Edgar J. Kaiser Certified Consultant

Please login with a confirmed email address before reporting spam

Posted: 9 years ago 2015年8月13日 GMT-4 13:40

Cheng-Ming,

my guess would be that the Hphi component is not well defined at r=0.

Cheers
Edgar

--
Edgar J. Kaiser
emPhys Physical Technology
www.emphys.com
Cheng-Ming, my guess would be that the Hphi component is not well defined at r=0. Cheers Edgar -- Edgar J. Kaiser emPhys Physical Technology http://www.emphys.com

Note that while COMSOL employees may participate in the discussion forum, COMSOL® software users who are on-subscription should submit their questions via the Support Center for a more comprehensive response from the Technical Support team.